Wave-Current Forces on Vertical Cylinders in Side-by-Side Arrangement for Irregular Waves Combined With Opposing Current

- The wave-current forces on vertical piles in side-by-side arrangement induced by irregular waves with opposing current are investigated experimentally in this paper. The characteristics in both time and frequency domain of in-line, lift and resultant forces are analyzed. The grouping effect coefficients of inline, lift and resultant forces on piles related to KC number and relative spacing parameters are given. These results are compared with those in the case of irregular waves combined with following currents. It is found that the results in these two cases are quite different. The range of KC number tested is 10- 60, the range of Reynolds number is (0.55-3.43) ×104.     

Test Study on Current Force on Mooring Ships

In respect of an offshore berthing pillar, the test study result of current force acting on mooring ships is described in this paper. Empirical and semi-empirical relationships of current force coefficient are given according to the angle between the flow direction and the ship's longitudinal axis, which are coincident with the result of theoretical analysis.     

A Computational Model for Velocity Separation in Shallow Sea

Based on the hydrodynamical feature and the theoretical velocity profiles of tidal flow and vvind-induced flow in shal-low sea, a computational model is established for the first time, which can separate observed velocity into tidal velocity and wind-induced velocity by use of the least square method. With the model, not only the surface velocities of tidal flow and vvind-induced flow are obtained, but also the bed roughness height is determined and the wind velocity above the wa-ter surface is estimated. For verification of the model, the observed velocity in the Yellow River Estuary and the laborato-ry test is separated, then it is applied to the Yangtze River Estuary. All the results are satisfactory. The research results show that the model is simple in method, feasible in process and reasonable in result. The model is a valid approach to analysis and computation of field dala, and can be applied to separate the observed velocity in shallow sea; at the same time, reasonable boundary conditions of th     

A Nonlinear Model of Surf Beat

A nonlinear short-wave-averaged (surf beat) model is presented. The model is based on that of Roelvink (1993), but the numerical techniques used in the solution are based on the so-called weighted-averaged flux (WAF) method (eg Watson et al., 1992), with time-operator splitting used for the treatment of some of the source terms. This method allows a small number of computational points to be used, and is particularly efficient in modelling breaking long waves. The short-wave (or primary-wave) energy equation is solved using a more traditional Lax-Wendroff technique. Results of validation indicate that the model performs satisfactorily in most respects.     

Wave Loads and Protective Techniques of An On-Shore Wave Power Device

In this paper, the extreme wave loads on an on-shore wave power device are investigated. First, boundary element method is applied to solve the three dimensional potential problem based on the small amplitude wave assumption. Then the motion of the Oscillating Water Column (OWC) inside the device and its laods on the device are calculated in time domain. Several protective techniques often applied are simulated by changing the constraint of the upper end of the chamber of the device. Numerical results are used to judge the effectiveness of these techniques. The investigation shows that damping can not effectively restrain the motion of OWC when the period of incident wave is long, which may cause dangerous loads on the structure. The shut chamber can effectively restrain the motion of OWC, but alternatively cause high pressure in the chamber. A Contracting opening with a Taper (CT) can exhaust a great amount of kinetic energy of OWC, and significantly decrease the loads. It is a promising protective tec     

Effect of Berm Width and Elevation on Irregular Wave Run-Up

This paper discusses the effect of berm width and elevation of composite slope on irregular wave run-up. Based on the data obtained from model tests, the formula and distribution of irregular wave run-up on composite slope are derived. The changing of wind speed, width and elevation of the berm are considered comprehensively. The wave run-up with various exceedance probability can be es-timated utilizing the distribution curves of irregular wave run-up.     

Numerical Analysis of Wave Forces on Arbitrarily Shaped Multi-Pillars Over Varying Topography

The modified hybrid element method (MHEM) is utilized to predict and analyze wave forces on arbitrarily shaped multiple bodies. This method can be applied to waves of all water depths, i. e. shallow, intermediate, and deep waters, on slowly varying seabed. The MHEM employs the ICCG method to save CPU and storage, thus the computation of wave forces for large multi-body systems can be carried out on microcomputers. Numerical results of the present method are compared with experimental data and other solutions. It is shown that the MHEM provides more accurate solutions of the wave forces than other numerical methods do. Therefore, the methodology presented herein can be used in the design of coastal and ocean structures.     

南海黄鲷性腺发育的初步研究

本文采用常规的生物学调查方法并取黄鲷性腺做石蜡切片，用显微镜观察黄鲷的性腺发育，进行组织学研究．其结果表明，南海黄鲷精巢可分成6期，精巢5期的成熟度指数为1．62％～2．71％，平均值为1．99％．雌性生殖细胞可见5个时相，卵巢发育也相应分成6期，卵巢5期时的成熟度指数为8．90％～13．90％，平均值为9．45％．南海黄鲷的繁殖期在11月至翌年的4月，繁殖高峰在12月至3月，黄鲷的产卵类型属于在同一繁殖季节中多次产卵类型．本文还对黄鲷的雌雄同体现象、繁殖力、繁殖时间进行了讨论．     

海底沉积物分析测试方法标准的研究

依据海底沉积物分析测试方法标准研究的总体设计，完成了40个分析项目的21份验证报告，进行了实验室间精密度协作性检验工作，在海底沉积物CaCo3,H2Os^-，H2O^ 的分析方法研究中取得新进展，并建立了ICP－AES法测定海底沉积物中常量、微量、稀土元素分析方法。     

Wave-Current Forces on Small Square Cylinders (Part I)

-Based on the extended Morison Equation and model tests, the in-line forces on small square cylinders caused by waves (regular and irregular) and currents are analyzed in detail in this paper. The hydrodynamic coefficient CD and Cu related to KC number and the effect of direction of wave incidence are also given, which can be used in engineering practice.